Panasonic mini split error code H19

Common causes

• Debris jamming the blower wheel.
• A dirt-caked wheel.
• A failed fan motor or loose connector.
• A failed fan drive on the board.

How to fix it yourself

Work through the checks below first; they resolve most cases. If they do not, the repair itself may need a technician.

1. Reset the system: switch the breaker (or the outdoor disconnect) off, wait a full five minutes so the boards fully discharge, then switch it back on and restart from the remote.
2. With power off, remove the filters and spin the blower wheel by hand; it should turn freely.
3. Clean the wheel and reseat the motor plug.

Switch off power at the breaker before opening either unit. Capacitors in the outdoor unit hold a charge for several minutes after power is cut.

When to call a technician

A fan motor is a moderate DIY swap; if it spins freely and the plug is tight, the board is the suspect.

Which Panasonic units show H19

This page applies to Panasonic Exterios, ClimaPure and Multi-zone (CU-xE) units. Panasonic's own documentation lists H19 as "Indoor fan motor locked", the same definition used across the Panasonic it is built on. If your unit shows a code with a different shape (for example a four-character code, or a plain number), it is from a different table; use the lookup with your exact code.

Where Panasonic shows this code

The indoor unit blinks its Timer lamp when a fault is stored. To read the code, point the remote at the unit and hold the CHECK button (on the back of the remote, under the flap on most models) for about 5 seconds until -- shows, then press the temperature up or down button; each press shows a code, and the unit beeps continuously (not a short beep) when the code shown is the stored fault. H codes are faults (a sensor, motor or board that needs attention). F codes are protections: the outdoor unit stopped itself because of pressure, temperature or current.

Other Panasonic codes

Same part of the system as H19:

All Panasonic error codes