Blueridge mini split code H1

What to do

You can almost always clear this yourself with the steps below.

1. Wait; heating resumes on its own.
2. If it runs longer than about 15 minutes or cycles constantly, the outdoor coil may be blocked or the coil sensor faulty.

When to call a technician

This is not a fault. No technician is needed unless it will not clear.

Which Blueridge units show H1

This page applies to Blueridge BMKH wall-mount, floor-ceiling and multi-zone (2016 and later) and BMY / BMX S-series single-zone (2023 and later) units on the BMKH series (Gree-built). Blueridge's own documentation lists H1 as "Defrost cycle running", the same definition used across the Gree platform it is built on. If your unit shows a code with a different shape (for example a four-character code, or a plain number), it is from a different table; use the lookup with your exact code.

Where Blueridge shows this code

BMKH series (Gree-built): The code shows on the indoor unit's display in place of the temperature. If the display is off, press the Light button on the remote. Some models also count out the code as indicator blinks. E codes are system protections and faults, F codes are mostly sensor faults, H codes are outdoor and compressor protections, U codes are motor and valve faults, and P codes are power-supply faults.

Other Blueridge codes

Same part of the system as H1:

All Blueridge error codes

H1 on other brands

The same characters do not always mean the same thing. Check the brand on your unit.

• Gree H1 Defrost cycle running
• Zone Air H1 High-pressure switch operated