Lennox mini split error code E6
PFC module protection (outdoor display).
- TypeProtection
- SystemPower supply
- Can I fix it?Technician job
- Applies tomulti-zone outdoor unit display
What E6 means on a Lennox
The power-factor-correction stage reported a fault three times in 15 minutes and locked out.
On this platform, E6 is a protection: the system stopped or throttled itself to prevent damage; many clear on their own once conditions return to normal.
Common causes
- Unstable supply voltage or a surge.
- A failed PFC module or board.
How to fix it yourself
Do the reset and the visual checks, but the underlying repair needs a technician with a meter and the service manual.
- Reset the system: switch the breaker (or the outdoor disconnect) off, wait a full five minutes so the boards fully discharge, then switch it back on and restart from the remote.
- If you own a multimeter and are comfortable using it, measure the supply voltage at the outdoor unit's L1 and L2 terminals with the unit running. A 230 V system should read roughly 208 to 253 VAC.
Switch off power at the breaker before opening either unit. Capacitors in the outdoor unit hold a charge for several minutes after power is cut.
When to call a technician
Usually a board replacement.
Which Lennox units show E6
This page applies to Lennox MPA / MPB / MLA single-zone, MPA / MPB / MLA multi-zone, MCB / MWCB, MWMA / MWMB, MCFA / MCFB and MMDA / MMDB units on the multi-zone outdoor unit display. Lennox's own documentation lists E6 as "PFC module protection (outdoor display)", the same definition used across the Midea multi-zone outdoor unit display it is built on. If your unit shows a code with a different shape (for example a four-character code, or a plain number), it is from a different table; use the lookup with your exact code.
Where Lennox shows this code
multi-zone outdoor unit display: These codes appear on the small LED display on the multi-zone OUTDOOR unit's control board (behind the service panel, or visible through a window on some models). The indoor units show their own, different codes for the same fault, so check which display you are reading. On the outdoor display, E codes are outdoor faults, F codes identify which zone's coil sensor failed (F1 = zone A, F2 = zone B, and so on), and P codes are protections.
Other Lennox codes
Same part of the system as E6:
E6 on other brands
The same characters do not always mean the same thing. Check the brand on your unit.
- Pioneer E6 PFC module protection (outdoor display)
- Blueridge E6 Communication error between indoor and outdoor units
- Zone Air E6 Indoor unit DC fan fault
- Daikin E6 Compressor start failure
- Mitsubishi Electric E6 Communication error between indoor and outdoor units
- Trane E6 Indoor unit DC fan fault / Communication error between indoor and outdoor units
Questions people ask
Can I reset a Lennox E6 code myself?
Yes. Turn the system off at the breaker for five minutes, then restart it. If E6 comes back, the fault is real and needs the checks above.
Is it safe to keep running a Lennox showing E6?
Not repeatedly. A protection code means the unit stopped itself to prevent damage, and resetting it over and over can turn a cheap repair into a compressor failure. Reset once, check the basics, and stop if it returns.
What will a technician check for E6?
Usually a board replacement. Ask for the measurements, not just a parts quote.
Sources
- Lennox Corp1816-L7 Mini-Split Systems Service Manual: Indoor and Outdoor Unit Error Codes (MPA/MPB/MLA, MWMA, MCFA, MMDA), 10/2020
- Lennox MCB / MWCB Mini-Split Service Manual (error code table 2.1)
Updated September 2026. Codes and definitions vary by model year. If your manual disagrees with this page, your manual wins. Send a correction.